Elmer's Multi-Purpose Spray Adhesive
0.0
(0)
How to get it
Details
Elmer's Multi-Purpose Spray Adhesive
4.00 OZ, 0.1 lbs. Item # 492688
Allows For Repositioning Dries Permanent Fast Tack, Dries Clear Resists "Bleed Through" Acid Free, Photo Safe With Wide Pad Nozzle For No-Mess Application Not recommended for use on vinyl materials or automotive headliners. USES: Elmer's "fast tack" Spray Adhesive is a strong, water-resistant adhesive which provides a permanent or temporary bond on a wide variety of materials. Will not swell or warp. Resists "bleed-through". FIRST AID TREATMENT: If eye contact occurs, rinse with tap water for 5-10 minutes. If irritation persists, seek medical care. If inhalation symptoms occur, move to fresh air. If symptoms persist, see a physician. For further health information contact a poison control center or call 1-888-516-2502. CARB Category: Mist Spray Adhesive. VOC content is less than 65% by weight. No lead in formula; No fluorocarbons; No methylene chloride; No hexane; No methoxy or ethoxyethanol or their acetates. This product was manufactured for and intended for consumer use. It is labeled according to the Federal Hazardous Substances Act. Should product be used in the workplace, Material Safety Data Sheets may be obtained at www.elmers.com. Spray Adhesive Great For: Dries permanent
Fast tack
Clear dry
This item cannot be shipped to the following locations: AA, AE, AK, AP, GU, PR and VI
Fast tack
Clear dry
This item cannot be shipped to the following locations: AA, AE, AK, AP, GU, PR and VI
| Color | White |
|---|---|
| Product type | Spray adhesives |
| Quantity | Single pack |
Directions
PREPARATION: Shake can well before using. Protect surrounding area from overspray (dried adhesive will remain slightly tacky). Point spray button opening away from you with can 6 to 8 inches from surface to be bonded. Spray an even coat. Important! To avoid possible clogging, turn the can upside down and spray a short jet of clear gas after completing job. APPLICATION: For Temporary Bonds: Spray a light coat and allow to dry for 3-5 minutes before joining. To remove, work a corner loose and peel back. For Permanent Bonds: Join surfaces within 15 seconds while adhesive is still tacky. Allow to set at least one hour.
From Elmers
*Customer reviews and ratings solely reflect the views and opinions of the individual contributors and are not created or endorsed by CVS Pharmacy. Please review the product labeling and consult with your doctor with any health or medical questions.
Elmer's Multi-Purpose Spray Adhesive
0.0
(0)